The new Klark Teknik DN100 Direct Injection Box is the natural successor to the long-established LBB100.
A ground-up redesign provides an extended dynamic range, lower noise floor and all the world-class audio performance you'd expect from Klark Teknik. DN100 is also designed to handle the rigours of life on the road: a thick aluminium shell protects the electronics, and this in turn is protected by a tough silicone rubber casing, which is replaceable and available as a spare part.
It is also fitted with a Kensington security slot in one of the end panels to allow the unit to be made secure using a Kensington MicroSaver security cable.

Attention to detail – it's what makes a good unit into a great one.

MPN: DN100
UPC: 410000150894

Input
Type active electronic, balanced or unbalanced
Impedance 1M ohms nominal, balanced or unbalanced (jack connectors)
20K ohms (XLR input only)
Connectors 2 quarter inch jacks and 3-pin XLR linked in parallel
Max. Level 30dBu
Attenuator 30dB, switchable

Output
Type Transformer Isolated, balanced
Impedance 300 ohms
Connector 3 pin XLR
Max. Level 10dBu with load >2k ohms
Min. load 600 ohms

Performance
Noise -100dBu, 20Hz to 20kHz unweighted, with input terminated by 10k resistor
Frequency response +0.5/-1dB 20Hz to 20kHz
Distortion (THD+N) <0.01% @ 1kHz, +4dBu output

Power Requirement
Voltage +48V Phantom *
Current consumption <10mA
Weight <1kg
Dimensions
Length 142mm (5.6 inch)
Width 106mm (4.2 inch)
Height 60mm (2.35 inch)

* The DN100 has been designed to allow use at phantom voltages less than +48V. The unit will function down to +20V (when used with 6k8 dropping resistors) but with reduced headroom and dynamic range. All the specifications above are quoted using standard +48V Phantom power.