Voltage Regulator and Power Conditioner
Product Code 43341
Buy Today and Save $249.05 (15% from Retail)
We're sorry, this product is no longer available.
The AR-20 II from Furman regulates voltage to deliver a stable stream of AC power that protect equipment from problems caused by AC line voltage irregularities. No more sags, brownouts, or over-voltages-all of which can cause sensitive electronic equipment to malfunction or to sustain damage. Featuring a generous 20-amp capacity, the AR-20 II regulator accepts any input voltage from 97V to 137V and transforms it to a constant 120V. Voltages beyond this range are also converted to usable levels, unless they are extremely far out of range, in which case the unit will automatically power down to prevent equipment damage.
The Furman AR-20 II filters and purifies AC power, reducing line noise linearly and ensuring optimum performance. Your equipment will perform at optimum levels and will be fully protected from spikes and surges by Furman’s exclusive SMP+ technology. This virtually maintenance-free surge suppression system incorporates Linear Filtering Technology (LiFT), Extreme Voltage Shutdown (E.V.S.), and high current TVZ MOVs to provide the highest level of power protection available-all without the need for servicing or replacement of the unit. Just install it in your rack and forget about it!
The AR-20 II voltage regulator’s circuitry monitors the incoming line voltage with each cycle, comparing it to an extremely precise voltage reference, accurate to ±0.15%. The design is not sensitive to small errors in line frequency, making it ideal for use with generators. If a voltage fluctuation requires that a different tap be selected, the new tap is switched electronically at the zero-crossing, to avoid distorting the AC waveform. (Most commercial voltage regulators using multiple-tapped transformers switch taps at uncontrolled times, thereby creating voltage spikes, and often creating clicks that can leak into the audio.)
The AR-20 II has twelve outlets on the rear panel and two convenience outlets on the front panel. All outlets are regulated, spike-suppressed, and filtered against radio frequency and electromagnetic interference. The twelve rear outlets are divided into two separate banks with bi-directional filtering for either analog or digital components. There are no controls except for the on-off switch. A digital meter indicates input voltage, while another LED indicates "In Regulation" status (i.e., that the output voltage is within ±5V of 120V). The unit is housed in a compact, dual-space rack mount chassis, 3.5" high and 17.125" deep with rack ears (14.125" deep without rack ears).
Furman’s SMP+ surge suppression virtually eliminates service calls. Traditional surge suppression circuits sacrifice themselves when exposed to multiple transient voltage spikes, requiring the dismantling of your system, and repair of your surge suppressor. Not so with SMP+. With Furman’s SMP+, damaging transient voltages are safely absorbed, clamped and dissipated-no sacrificed parts, no service calls, no down time.
Unique to Furman’s SMP+ is its unparalleled clamping voltage, even when tested beyond the grueling specifications of USA/CIDA’s A-1-1 test. While other designs offer clamping voltages that are well above 300VAC peak (far beyond long accepted professional standards), Furman’s SMP+ clamps at 188VAC peak, 133 VAC RMS even when tested with multiple 6000VAC-000 amp surges. This unprecedented level of protection is only available with Furman’s SMP+ technology.
Traditional AC filter/conditioners have been designed for unrealistic laboratory conditions. Prior technologies could actually harm audio and video performance more than they help, due to the resonant peaking of their antiquated, non-linear designs. Under certain conditions, these designs can actually add more than 10 dB of noise to the incoming AC line! Worse still, lost digital data, the need to reboot digital presets, or destroyed digital converters are frequently caused by excessive voltage spikes and AC noise contaminating the equipment ground. Furman’s SMP+ with LiFT takes another approach, ensuring optimal performance through linear filtering and no leakage to ground.
Furman’s trusted overvoltage circuitry protects against all too frequent accidental connections to 208 or 240VAC by shutting off the incoming power until the overvoltage condition is corrected.
MPN AR20II 0 0
- Current rating: 20 amperes for input voltages of 104/124 or higher; derate at 113 mA per volt to a minimum of 12.3A
- Spike protection modes: Line to neutral, zero ground leakage
- Spike clamping voltage: 188 Vpk @ 3,000 amps, 133 VAC RMS (tested to UL-1449 6,000 Vpk @ 3,000 amps)
- Response time: 1 nanosecond
- Maximum surge current: 6,500 amps
- Voltmeter accuracy: ±1V
Noise attenuation (Linear attenuation curve from 0.05 to 100 ohms line impedance)
- 10 dB @ 10 kHz
- 40 dB @ 100 kHz
- 100 dB @ 10 MHz
- "In Regulation" ranges: Regulates to 120V ±5V from 97 to 137V
- Shutdown range: Above 137 VAC typically
- Dimensions: 19"W x 17.125"D x 3.5"H
- Weight: 36 lbs.
- SMP+ provides the highest level of protection available
- LiFT significantly reduces AC line noise
- E.V.S. protects equipment from dangerous overvoltage conditions
- Zero ground contamination circuitry assures delivery of pure AC
- Precise Voltage Regulation delivers a consistent, stable 120 volts output to safely power connected equipment and optimize performance regardless of fluctuations in the input level
- Ultra-low noise torodial autoformer assures no mechanical noise or hum-inducing magnetic field
- Fourteen AC outlets with two bi-directionally filtered banks to isolate digital and analog components
- Output capacity 20 amps
- Includes a limited three-year warranty covering defects in materials and workmanship
Description$1,299.99 Add to cart
32-Channel Mixer w/ High-power Dual DSP Engine w/ Improved Digital Effects & Output Processing Including Feedback Ferret, 28-band GEQ/5-band PEQ, Delay & Limiter
Description$999.99 Add to cart
24-Channel Mixer w/ High-power Dual DSP Engine w/ Improved Digital Effects & Output Processing Including Feedback Ferret, 28-band GEQ/5-band PEQ, Delay & Limiter
Description$995.00 Add to cart
Elite Roll Top Rack
Description$269.00 Add to cart
4-channel 24-bit/192kHzl USB Audio/MIDI Interface
Description$199.99 Add to cart
Deluxe 4 Space Rack Case
Description$44.95 Add to cart
Locking Power Strip
Description$34.99 Add to cart
25 Foot Power Cord, IEC C13 to NEMA 5-15P