Supercardioid condenser lavalier microphone with 4’ (1.2 m) attached cable, belt-clip preamp with XLR, rotable tie clip, dual tie clip, snap-fit windscreen

They're no bigger than a paper clip unless you consider the sound they produce. The new Microflex Lavalier microphones bring a new level of sophistication to personal voice reproduction. Like all Microflex family microphones, the new Lavaliers use Shure's interchangeable condenser cartridges, available in cardioid, supercardioid or omnidirectional polar patterns. That means you can be sure there's a Microflex Lavalier that's right for your job.

Each Microflex Lavalier includes all the accessories you need: Pivoting, Single-Microphone Tie Clip Dual Microphone Tie Clip Black, Snap-fit Foam Windscreen Belt-Clip Preamp 4-foot cable with 4-pin TA4F Connector.

The Microflex Lavaliers are completely compatible with all Shure Wireless transmitters, and their high sensitivity and wide frequency response guarantee great sound with a minimum of RF interference or electromagnetic hum. Plus, each Microflex Lavalier features the same Shure quality sound that has become an industry standard.

MPN: MX183

Features
Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum

Interchangeable cartridges that provide an optimal choice for each application

Rotatable tie-clip that pivots in 90 degree increments for placement flexibility

Supplied snap-fit foam windscreen that controls breath noise and stays on securely

Balanced, transformerless output for increased immunity to noise over long cable runs

Supplied dual tie clip holds two microphones for dual miking applications


Specifications
Type: Condenser (electret bias)

Frequency Response: 50-17,000 Hz

Polar Pattern: Omnidirectional

Output Impedance: EIA rated at 150 ohms (180 ohms actual)

Open Circuit Sensitivity (at 1 kHz, ref. 1V/Pa): -27.5 dB (42.2 mV)

Max SPL (1kHz at 1% THD, 1 kohm load): 116.7 dB

Equivalent Output Noise (A-weighted): 20.5 dB

Signal to Noise Ratio (referenced at 94 dB SPL): 73.5 dB

Dynamic Range at 1 kohm load: 96.2 dB

Power Requirements: 11-52V DC Phanotm, 2.0 mA

Common Mode Rejection: 45.0 dB minimum

Polarity: Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector

Environmental Conditions
Operatine Temperature Range: -18 to 57 degrees C (0 to 135 degrees F)

Storage Temperature Range: -29 to 74 degrees C (-20 to 164 degrees F)


Cable: Shielded 1.2 meter (4 ft.) cable terminated with a 4-Pin Female Mini Connector (TA4F)

Dimensions
Capsule: approx. 12mm (0.46") diameter, 22mm (0.85") length

TA4F connector: approx. 20mm (0.79") diameter, 99mm (3.89") length