Welcome to the CleanBOX II from ART! "Hum" in an audio system is often caused by loop effects which act like antennas. These loops can easily pick up a 60 Hz (or higher harmonics) hum transmitted by electrical wiring. Typically, these loops are connected via grounds, more commonly called "ground loops". The safest way to eliminate unwanted noise is with ART’s CleanBOX II.
Some examples of Ground Loops:
The power ground of a synthesizer, connected to the signal ground of the synth, into a mixer’s ground, then into a mixer’s power ground.
The signal ground of a send effect (reverb, delay) into a mixer, and the connecting power grounds of the mixer and the unit.
The power ground of a guitar amplifier, connected to a signal processor which has a second guitar amplifier on the other channel, and then the second guitar amp’s power ground.
The CleanBOX II from ART easily removes ground loops without any signal degradation!
Virtually indestructible, compact steel chassis
Two independent channels for two correcting two ground loops, or for processing stereo signals
1/4" TRS input and output jacks supporting balanced or unbalanced connections
Unity gain. A signal into the CleanBOX II will be the same level at the output
10Hz – 50kHz, +/- .5dB @ +4dBu
.01% Typical @ 1kHz, +18dBu, <.05% @ 100Hz, +24 dBu
4dB @ 100kOhm Load, 5.5dB @ 600Ohm Load
1/4” TRS balanced/unbalanced jacks
2V DC (not included)
4.5 x 2.875 x 1.5 inches
(114mm x 73mm x 38mm)
1.9 lbs (0.9 kg)
Description$269.99 Add to cart
Handy Recorder with Interchangeable Microphone System
Description$169.95 Add to cart
Cardioid Vocal Stage Microphone
Description$169.00 Add to cart
Acoustic Instrument Processor
Description$65.00 Add to cart
2 Channel Level Converter
Description$25.00 Add to cart
Gift Certificate (may be purchased in multiple amounts)
Description$14.95 Add to cart
Dual 1/4 inch TS Male to Dual RCA Male Stereo Audio Cable
Description$9.95 Add to cart
6 foot Instrument Cable