The regulated 48 Volt DC output is ultra quiet, introducing no noise into the microphones' signal path. The Micpower 2 is conveniently portable, operating on four long lasting AA batteries or on AC when desired, by connecting the included PS6V2.5A power supply. The rugged design is perfect for field recording applications when the use of high quality microphones requires external phantom power.
MPN MICP2 0 0
- XLR Jacks - The female XLR is used for the input connection from a microphone. The male XLR is used for the output connection to a mixing console. The phantom DC voltage is blocked to the output to avoid the loud popping that occurs when plugging in equipment that is turned on.
- Power On/Off Switch & Power/Battery Sensor LED - When the power switch is in the ON position, the LED will illuminate if the batteries are supplying sufficient power to operate the unit (at least 13VDC to a microphone at 4mA). Replace the batteries if the LED fails to light when the On/Off switch is in the ON position.
- Battery Installation - A fresh set of alkaline batteries will provide approximately 50 hours of continuous operation at a constant 4mA load. To install or replace the batteries, loosen the thumbscrew located on the end of the unit. Depress the female XLR release button and swing open the hinged cover. Snap batteries into the holders, close the cover and tighten the thumbscrew. Always replace both batteries.
Description$299.95 Add to cart
System10 Digital Wireless System w/ Handheld Dynamic Unidirectional Microphone/Transmitter
Description$299.00 Add to cart
Advanced 4x4 USB 2.0 Recording System
Description$229.95 Add to cart
2-Channel Mic/Instrument Tube Preamp
Description$229.00 Add to cart
Large-diaphragm Condenser Microphone with Popshield, Shockmount and XLR Cable
Description$69.99 Add to cart
Gold-Sputtered Diaphragm Condenser Microphone
Description$39.95 Add to cart
High-quality microphone cable
Description$19.95 Add to cart
25 foot Microphone Cable, XLRM to XLRF